It is very common for screws in drywall to become loose overtime. This bubbling, blistering, or bumpy effect in walls is due to the drywall pushing out the screw or nail heads since it shifts. This is known as nail pops in the drywall industry. Generally, this is a sign your walls may be needing fresh drywall work and paint.

For dc drywall repair nail pops, you can sometimes repair them without professional assistance. For larger or more complex jobs, a professional drywall contractor is the best resource given that they retain all the appropriate tools, equipment, and training. In the event that you want to fix a few nail pops around the house by yourself, continue reading to understand some tips for doing that!

Nail Pop Repair

To correct nail pops in your drywall, you will need a few supplies. You may have most of these materials readily available already, and anything you do not have can be found at your neighborhood home improvement or hardware store. Here's what you would need:

Stud Finder (optional)

Hammer (or nail punch)

2 Drywall Screws

Screwdriver

Drywall Mud

Drywall Knife

Sandpaper (200 grit is fine)

Paint and Primer

To get going, make sure to have all the mandatory tools and supplies in order that you don't have to stop halfway through to make a trip to the store. After you have all you need, start with locating the framing around the area with nail pops. Use your fingers to tap the wall until you can hear a solid reverberation rather than an empty one. You may even make use of a stud finder. Once you find a sharper sound, tap each side to make certain it sounds hollow. If this happens, then you definitely have located the framing.

Next, utilize the drywall repair dc screws to re-attach the loosened drywall to the framing. Place each screw 2 to 3 inches above and below the nail pop. Then use your hammer to depress the nail pop back into the wall. Do this task gently as not to put a hole or dent in the wall.

Utilize the drywall knife to scrap away any excess drywall material that has flaked or crumbled off. Then utilize the drywall mud to cover the screw heads in the wall. Two coats have to do the trick. Follow the instructions or search for online tutorials on how best to apply drywall mud.

Last, use your sandpaper to sand the drywall mud until it is even and smooth. Then just finish the task with a new coat of primer and paint.