ONE PARTICULAR. Cooling water system with EPS moulding machine appearance factory

Separate the cooling water for mould using the water for vacuum. Employing a high efficient vacuum procedure, the machine should mainly make use of vacuum cooling while taking into account water cooling as subsidiary, which could greatly increase the productivity.

Adopting high temperature chilling water (50-55 degrees) in order to cool the eps mildew, yet cold cooling mineral water (25-35 degrees) for vacuum spray and vacuum knock out. Different water temperatures won't increase the service lifetime of mould and cleaner pump, but also improve the cooling speed a ton because vaporized high-temperature h2o absorbs the heat in addition in vacuum environment.

A COUPLE OF. High efficient vacuum program

It adopts the principle of central vacuum technique that vacuum kept within the pipe constantly. When cooling is essential, hot air inside the mould is going to be sucked out quickly, concurrently the vaporization of this high-temperature water also takes a large number of heat away, which enables the mould to be cooled down speedily. The heat taken from the vaporization of 1KG water is add up to the heat taken by means of 7KG cooling water with 25 degrees spraying onto the mould.

3. Three separate water pools in combination with primary and secondary cooling towers to overpower three different water temps.

Hot pool: 65-75 level. Water used for the boiler is often taken from here via filter. It should be cooled with the primary cooling tower then transported for the mould cooling pool.

Mould cooling pool, temperature may very well be 45-55 degree, used to get mould cooling. It is suppose for being delivered to vacuum soothing pool via secondary customizable water tower.

Vacuum air conditioning pool: temperature is somewhere between 25-35 degree used for cooling vacuum tank bottle of spray and vacuum pump.

SEVERAL. You are recommended to use central vacuum system if there are actually more than 3 EPS moulding machine as part of your factory.

Central vacuum system gives expression to high economical efficiency to get more detailed than 3 EPS moulding unit, power saving at the very least 40%, and greatly improvement belonging to the production. We recommend one-bye-one association (modular type) but somewhat independent central vacuum technique, Every set of central vacuum system could support utmost 15 EPS moulding appliance, and every single vacuum technique are connected to main tube, which besides is segregated by manual butterfly valves. This means vacuum stays equally with every section, and the plant won't be interrupted as a new matter of vacuum dilemma.

eps mould machine. JPG.
where can i buy Pre expander Machine 201911ld